The List Admin utility is used to setup and administer the List Locate application.
This application is used to define what Tabs will be defined in the List Locate application, to define the Event Processor and Alert Server to be used by the List Locate Application and the various fonts and display columns to be used by the List Locate Application.  This application can be launched directly from the List Locate Application or it can be run independently.  This application MUST be run before List Locate can be used. 

A typical Tab Definition screen is shown below.  Before this application can be used a password must be entered.  If this application is launched from List Locate, the password will be requested from List Locate.

In the Tab Definition screen the filters to be used by List Locate need to be selected.   This is done by selecting a filter from the Defined Filters display and then clicking the Add Filter as Tab command button.  A typical display of this is shown below.

Tabs are displayed in the order they are listed in the List Locate Tab Definitions Window. 
The following commands can also be used to change the tabs used by List Locate.

The Following screen shows a typical List Admin configuration screen.

The First column (Y or N) defines if that column will be displayed.
The Second column (red number) shows the order of display.
The Third column allows you to change the descriptive name of a column.
The Fourth column is the display width of the column (characters wide).
The Fifth column is the justification of the column (L - Left, R - Right & C - Center).
The sixth column is the display format for that column.

The lower section of the screen is used to change the font style, size and color for five different display areas in the List Locate application.  The default colors and line usage can also be modified.

The format tab can be modified via the Tabs Per Page and the Multi-Row Tabs selection.  If Tabs Per page is set to 0 then a proportional tab (scrolling if necessary) will be used.

Once changes are made and the Quit or Exit button is selected, you will be given a chance to abandon or commit all changes.  If the OK command button is selected changes are accepted, if Cancel is selected than all changes are discarded.

Contact for more information on the Event Processing System.