List Locate displays People/Items by group. 
The List Locate Application only displays the people/items in a group and within the areas defined by the filtered locations.  The screen below is a typical List Locate Display when there are no People/Items in the defined area.

As People/Items leave and enter the area being monitored by the selected filter they will be automatically added and removed from the display list.  The screen below shows four selected items. The first and last have been seen with the "Not Seen Timer", the middle two items have not been seen for the not seen time interval.   This value is defined via the ListAdmin Utility or by clicking on the command button.  A typical List locate screen is shown below.

Additional Information regarding the current configuration, setup and available services of List Locate can be obtained by selecting the command button.  The following shows a typical List Locate Info Display Screen.

List locate can generate simple reports based on any or all of the selected filters.   Clicking  report command button will display a report menu allowing for report selection. 

Select the desired output location and report to start the reports production.
A typical output report is shown below.

When a button press occurs at filtered location a screen pop-up will occur indicating the alarm name and location.  A typical screen-pop is shown below.

Clicking the Alarm Log Command button allows for display of alarms which have occurred since this instance of List Locate was started.  A typical Alarm Log screen is shown below.

    The ListAdmin utility is used to setup and administer the List Locate application.

Contact for more information on the Event Processing System.